Crest-electronics CRE57074 RCC REMOTE SWITCH DEVICE 2.4 GHZ Manuel d'utilisateur télécharger pdf (Page 2)

Switches

In the front of the Remote Switch Device there are six terminals five for switch hookups “SW

-1 / SW –5” and one for power input “POWER –IN”. The Remote Switch Device will work with

the fowling switches:

1. Art 11298 Switch Machine Slow Motion New

2. Art 11299 Switch Machine Old

3. LGB switches [TM of Marklin]

4. Most Other G Gauge Switch Machines

Switch Hookups

The Art 11298 Switch Machine Slow Motion comes with wires to connect to the switch

machine and to the Remote Switch Device. Do not disconnect the toggle switch from the

wires; this will cause the switch not to work properly even when using with a Remote Device.

The red wire is hooked up to terminal A, the black wire is hooked up to terminal B and the

green wire is hooked up to the common terminal on the slow motion switch machine. Cut the

Plug on the black wires and connect it to the desired terminals marked “SW -1 / SW –5” on

the Remote Switch Device.

Note: The slow motion switch machine works on the SLOW setting only. See Fig 2

The Art 11299 switch machine and LGB Switches [TM of Marklin] use two wires to hook up on

the switch machine and Remote Switch Device.

Note: These switch machines work on the FAST setting only. See Fig 3

Page 2

1 2 3 4 5 6 7 8

Pas de commentaire

Crest-electronics CRE57074 RCC REMOTE SWITCH DEVICE 2.4 GHZ Manuel d'utilisateur Page 2