Crest-electronics CRE57074 RCC REMOTE SWITCH DEVICE 2.4 GHZ Manuel d'utilisateur télécharger pdf (Page 3)

Power Supply

The Remote Switch Device can be connected directly to a power supply 6 volts to 24 volts or

anywhere from your track layout. This unit can also use battery power 6 volts to 24 volts.

Aristo Craft carries a battery box to work with the Remote Switch Device, CRE 55612 if you

do not have track power available.

In the front of the Remote Switch Device there are six terminals five for switch hookups “SW

-1 / SW –5” and one for power input “POWER –IN”. Take the two wires from the power supply

and connect it to the terminal on the Remote Switch Device marked “POWER –IN” Power

Input.

DO NOT HOOK THE POWER WIRES ON THE FIVE TERMINALS MARKED “SW -1 / SW –

5” SWITCH. THIS WILL BURN THE MAIN BOARD OR CAUSE A SHORT .

Note: This unit is built with polarity protection

Linking the Remote Switch Device to the Transmitter

1. Press the menu button once to select Assign Function on the transmitter.

2. Press the Stop/Enter button to enter Assign Function.

Scroll down to choose the functions below:

a. Bind Address [00] Each Remote Switch Device must have its own bind address

number.

b. Rx TYPE: [ACESS] select ACESS by pressing the left or right arrow. This function must

selected when operating the Remote Switch Device.

c. NAME: [RX –1] Enter a name for the Remote Switch Device. Each device must have a

name before returning to the main LCD screen. Names recommend to enter for the

Remote Switch Device, [RX –1, RX –2, RX –3 etc]

Page 3

1 2 3 4 5 6 7 8

Pas de commentaire

Crest-electronics CRE57074 RCC REMOTE SWITCH DEVICE 2.4 GHZ Manuel d'utilisateur Page 3