Crest-electronics CRE57074 RCC REMOTE SWITCH DEVICE 2.4 GHZ Manuel d'utilisateur télécharger pdf (Page 4)

d. SW-TYPE: [1 –SLOW]: choose “FAST or SLOW” for the switch machines. Some switch

machine need different setting for proper operation. To change the settings on the

switch machines, [SW –1, SW –2, SW –3, SW –4, or SW –5], choose the switch

desired and press the number on the key pad. Press the right or left arrow on the key

pad to change the settings

e. TIMER: [1.0s] choose the time you want the switch to throw from “0.5 second to 5.0

second by pressing the right or left arrow on the key pad.

f. MULTI-SW “OFF”: Change this to “ON” use this function to activate two, three, four or

all five switch machines at the same time.

g. LINKING – Press the link button on the Remote Switch Device for until the red LED light

starts to flash. Let go of the link button and press the “Stop/Enter” button the

transmitter. After a few seconds the red LED will stop flashing and the transmitter will

show PASSED on the LCD screen. You are now linked and ready to operate you

switch machine. See Fig 4

Add the Remote Switch Device to the Main LCD Screen to Enable This Use.

1. Press the Menu button once to go to Main Set Up screen to add your Remote Switch

Device to the Main Screen.

2. Scroll down to Add MU/SU CAB and press the Stop/Enter button

3. CAB NO: CAB –0, Choose a cab number to operate the Remote Switch Device from “-0

to 49”. Each Remote Switch Device must have its own Cab number.

4. Scroll down to “SU [00] RX-1” mode and Select the Bind Address numbers that enter for

the Remote Switch Device. See Fig 5

Page 4

1 2 3 4 5 6 7 8

Pas de commentaire

Crest-electronics CRE57074 RCC REMOTE SWITCH DEVICE 2.4 GHZ Manuel d'utilisateur Page 4